Yes the digital outputs of the TAP range are designed to connect to the digital inputs of the Loxone Miniserver / Loxone Extensions, you can also connect ...
Sat, 25 Feb, 2017 at 12:14 PM
Yes, to power the electronics inside the switch plate the switch requires both 5-30V and GND to operate.
Mon, 29 Jul, 2019 at 10:52 AM
Yes the switch plate is designed that so you can connect multiple digital outputs from one or more TAP switch plates to the same digital input.
Mon, 29 Jul, 2019 at 10:53 AM
The Faradite TAP can fit cables with a conductor cross section min AWG 24 - max 20 AWG (We advise the use of CAT cable)
Mon, 29 Jul, 2019 at 11:00 AM
The temperature sensor is located at the bottom of the switch plate, and unlike other switch plates the TAP range exposes the temperature sensor to the ai...
Sat, 25 Feb, 2017 at 11:00 AM
The connectors are push fit connectors, to connect the wires you simply push the wires into the circular hole. To remove the wire you simple insert a small ...
Mon, 29 Jul, 2019 at 11:07 AM
Yes if you have say 3 TAP-5’s in a bedroom one either side of the bed and one by the door then you can connect all three TAP-5's to the 5 of the input...
Sat, 25 Feb, 2017 at 12:13 PM
Yes the TAP-5 can connect directly to the Nano DI Tree so you can get all the benefits of using third party switches with all the benefits of Tree wiring. Y...
Sat, 25 Feb, 2017 at 12:18 PM
You can use CAT5, CAT6, or CAT7, if you are installing a TAP-5 with 1-wire then all 8 cores of the CAT cable are used.
Tue, 30 Jul, 2019 at 7:52 AM